All best sellers
  • Banner

Sealing set for stove/boiler/fireplace Standard

Sealing set for stove/boiler/fireplace Standard

Tax included


Repair kit for stove/boiler/fireplace Standard

One repair kit consists of 2.5 meters of Standard sealing cord and one tube of glue. When buying a cord with a diameter of more than 10 mm, we suggest buying additional glue.

Sealing cord for furnaces Standard

  • Status: New
  • Cord diameter: selectable from the list
  • Cord length: 2.5 m.
  • Temperature resistance: 500°C
  • Material: fiberglass base weave
  • Application: sealing the connections of chimney systems with heating devices, sealing the doors of fireplaces, stoves or boilers.


  • Adhesive capacity: 20ml
  • Temperature resistance: 1100°C
  • Drying time: 4-5h
  • Application: fastening of gaskets made of ropes, tapes and cords made of glass fiber, basalt or silicon fiber and seals made of ceramic fibers to the doors of cookers, stoves, boilers and other heating devices.


We guarantee excellent product quality as the official distributor of the hermetic brand. We offer only original materials.

Effectiveness: Certified

Approval: PZH HK/B/0891/01/2015

Mounting method

  1. We do the work after the fireplace has cooled down, when it is cold.
  2. The cord is usually fixed in special grooves on the inside of the door. Put on protective gloves, take a screwdriver or similar tool to pry the existing cord; be careful, because maybe the old cord may fall apart. Use a brush (preferably wire) to remove the remnants of cord and old glue. Finally, degrease with a cloth moistened with denaturant (or other oily agent)
  3. Spread with a thin layer of glue at the bottom of the groove (the tube must be opened by unscrewing the cap and piercing the tube film with the reverse side of the nut); the lower part of the nut (dispenser) can be shortened as needed.
  4. Spread the glue along the length of the groove. When pasting a new cord, start from the center of the bottom of the door. Spread the cord along the entire length of the door, pressing it tightly. If you have to trim the end of the cord – do it with a neat, "clean" cut so that it fits snugly to the other end. You can not leave a gap between one and the other end.
  5. Press the gasket into the glue, without stretching it in the process of pasting; remove any excess glue with a damp cloth. The sealing side of the cord should not be soiled with glue.
  6. Close the door, then open and check that the gasket has fit snugly. Leave to dry for at least 4-5 hours, without closing the door
  7. It is best to ignite in the fireplace with a small flame so that the glue additionally hardens. To be sure, you can re-perform the door tightness test with a piece of paper. Now you are ready for the new heating season!
  8. When replacing the gasket, all activities should be carried out in protective clothing.
Product Details

Write your review

Sealing set for stove/boiler/fireplace Standard

Sealing set for stove/boiler/fireplace Standard

Write your review
9 other products in the same category:
You might also like

Follow us on Facebook